PWS-ATX1000-N12S

atx1000n12s_2-1

1000W ATX 12V Power Supply

1000W ATX 12V Power Supply
Higher capacity and more air flow


Shipped in easy-to-carry retail box

Low Noise

  • Strong 1000-Watt for PC and server application
  • Lagacy and newest AMD and  Intel i7 CPU supported
  • New in easy-to-carry retail box
  • Quiet Operation
  • Energy-efficient with less heat and wastes less electricity
  • Optimized cooling design
  • Long cables to support mid and full tower cases
  • Black casing with black mash cable sleeves on all cables

NEW Better Mechanical Design:

Large 120mm fan draws massive amounts of hot air in from the CPU into the power supply and exits out the back of the PC.  Since the fan is situation inside the system and not at the back of the PC, audiable fan noise is greatly reduced.



Product  Specifications
AC INPUT 115V/230V – 60/50Hz
DC OUTPUT +3.3V +5V +12V1 +12V2 -12V +5VSB
1000W Max
Combined
Peak Watts
33A 45A 34A 34A 0.8A 3A
1000W
  • Maximum Power Output: 1000W
  • Efficiency: Typical 70%
  • Manual shut-down rocker switch
  • Input: 100-127V AC or 200-240V AC – selectable by switch
  • Dimension: 150mm x 86mm x 156mm  (the 156mm length is the side that extends inside the case when installed)
Complete 5*Startm system protection
  • Over Voltage Protection
  • Under Voltage Protection
  • Over Current Protection
    • Short Circuit Protection
    • Over Power Protection
Connectors Details

1 x 20+4pin Main Power Connector (supports both 20 & 24pin motherboards)
1 x 4+4 12V Power Connector (supports standard 2×2 P4 & 2×4 8pin 12V boards)
2 x 6+2 PCI-E Power Connector, supports both 6pin and 8pin PCIe video cards.
(on two seperate line of cables for unrestricted reach)
4 x SATA Power Connector (on two seperate line of cables for unrestricted reach)
4 x Periphal Power Connector (on 2 seperate line of cables for unrestricted reach)
1 x Floppy Drive Power Connector

More Details
Massive 120mm fan draws heat from CPU area and cools the power supply at the same time.

Special slippery circular tube design fan-guard allows air to flow in smoothly and quietly while providing protection against unintended installation injury.

Black casing with black mash cable sleeves on all cables.   Sleeves provide protection for the wires.    Sleeve cover is receded approximately 6″ from power connector to provide enough clearance for ease of connection.
AC Voltage Selection Switch for 115 or 230v is strategically located inside the PC system after the power supply is installed.

This position protects your PC system from unintended tempering.

This entry was posted in ATX, Power Source, Products. Bookmark the permalink.